Any Length Aluminum Motor Mount for Canoe

Aluminum motor mount consists of one-piece rectangular tube going all the way across, with blocks of same material bolted on above and below at one end to clamp the motor to.

Gunwale clamps attach it to the canoe.

questions:  Jim@sailboatsToGo.com

tel 978-263-7598

The motor mount also can serve as the crossbar to accept the slip-on wheels we offer.   The prongs of the wheel frame slip into the ends of the motor mount crossbar.

This motor mount can also serve as the crossbar to accept our stabilizer floats and arms to prevent capsizing.    We just need to drill the hole pattern to accept the locking spring buttons on the stabilizer arms.  Request us to do that in the comment section of your checkout ($10 cost, which is waived if you buy the floats).

Sturdy large gunwale clamps grip well.  Clamps can be positioned outside the canoe for Coleman and the few other brands that have outside-lip gunwales or the can be inside for inside-lip gunwales.

Clamps slide to adjust to any width canoe.

This motor mount is 36 inches long over-all, with an 8-inch block on the end, leaving 28 inches to span the canoe.   If you want a different length, please specify in comments section of your checkout page.   We offer 40 inch and 45 inch lengths at no extra cost or custom lengths for $20 more.  Extra length can just overhang, so don't worry if it's a little longer than needed.

Stabilizer Float Options to add:  Hydrodynamic 1006, or  Ethafoam item 1002, or Inflatable item 1013   (Shown below is the ethafoam type, without motor mount block on the end that yours would have if you order this motor mount.  And of course, as a motor mount it be probably be  mounted behind the rear seat.)

Any Length Aluminum Motor Mount with Stabilizers for Canoes
Same as the 5215 but with the addition of hydrodynamic stabilizer floats (pontoons) to help keep your canoe from flipping. We drill the Any Length Motor Mount with the hole patten required to accept stabilizer pontoon float arms and provide a pair of streamlined hard plastic floats on telescoping arms. (Hydrodynamic floats). Floats are 42 inches long and 6 inches high. They adjust up and down and in and out. 5 year warranty on floats. Motors up to 3 HP.